Paneling & Molding (LN-606)

Key Features

• Retains precise placement
• Reduces nailing
• Impact resistant
• Instant-grab formula
• Strong, waterproof bond
• Contributes to LEED^® certification
• Contributes toward NAHB National Green Building Standard™ certification of the structure

Recommended For:

paneling, wainscoting, corkboard, wood, foam and plastic molding and MDF board.

NOT Recommended For:

uses other than paneling and molding, exterior use, use between two non-porous surfaces.

Available Sizes

• 10 fl. oz. cartridge

Coverage

• Using a 1/4" (.64 cm) bead: 10 fl. oz. cartridge covers 32 lineal ft.

Max VOC

69 GPL

• Download MSDS Sheets
• Download Technical Data Sheets

You need Adobe Reader to view PDF files.
You can download it here for free if you don't have it.

 

Surface Preparation

All panels must be separated and conditioned to room temperature for 48 hours prior to installation. Preparation: Surfaces must be clean, dry and structurally sound. Cut and pre-fit materials prior to installation.

Application Prep

1. Cut nozzle at a 45° angle to desired bead size (marked on nozzle). 2. Puncture inner seal with nail or wire. 3. Adhere materials within 20 minutes of gunning adhesive. Due to panel inconsistencies, for best results, bracing and/or nailing may be required. Humidity may extend dry time. Instant-grab method: Paneling — Apply 1/4" bead of adhesive approximately 1" from edge of panel around the perimeter. Apply two zig-zag 1/4" beads in the middle of the panel. Press panel firmly into place. Remove panel from wall for one minute. Rejoin panel to wall. Molding — Apply 1/4" zig-zag bead to back of molding. Press molding firmly into place. Starting at one end, nail every 12".

Cleanup

Water cleanup while wet. Mineral spirits when dry.

Buy Online

Visit these online retailers for a selection of Liquid Nails products.

Price and item availability may vary.

	homedepot.com
	lowes.com